Put
the tray full of ampoules into Model ACQ-II Ultrasonic Ampoule machine,
this machine begins spray waterautomatically. When the start-up signal
is displayed, press the PLC control button. The tray will be immersed
intowater under the control of man-machine interface auto-operation
and the ampoules will be feed into a position underthe ultrasonic transducer
by ultrasonic wave for about 60 seconds (the time may be adjustable).
Then, the trap entered a disk and turn over for 180º. Then, the
ampoules are left the water with their mouths downward and are carried
out external-wall drenching, and then, the ampoules are entered the
internal spraying station under the driving of thetray-passing cylinder
and are carried out internal-wall spraying and washing by water and
gas in three times circle-washing ( washing time and the times can be
set according to actual production requirements). After aboveprocedure
is finished, the ampoules are conveyed into a station, which is used
for draining the water inside ampoules, and drain this water fully.
Final, the ampoules are converyed into the 100 stage laminarflow protection
device between the bottle washing machine and tunnel type oven, and
then, the ampoules areputted into the tunnel type oven after bottle-turning
by manual operating.
Under the monitoring of intelligent system Model GMSU-400C chain type
Sterilizing oven, the tray full of
ampoules are successively entered the preheating zone, high temperature
sterilizing zone ( the temperature
of the probe is =350?; the sterilizing time is =5mins) and low temperature
zone of oven by the conveying of the
chain. The speeds of the convey chain are stepless adjustable. The temperature
control system is equipped withsome functions such as the control of
temperature setting and display with paper recording or non-paper recordingetc.,
in order to prevent pollute the 100 stage laminar flow protection devices
are supplied in the inlet section andoutlet section of the oven. After
cooling, the ampoules which are dried, non-fungus and left the heat
source aretook out form the tray by manual operation, and are entered
the wire-drawing, filling and sealing machine, and are carried out the
filling and sealing for ampoules.
Ampoules in bulk are fed into the bottle-feeding passageway of Model
AGF 6-ampoule wire-drawing, filling andsealing machine by the conveying
belt. The ampoules in group by 6 bottles are placed in the dividing
disk and are intermittently and sequentially fed into the sations of
nitrogen filling, wire-drawing, sealing, and carried outthe filling
and sealing under the protection of 100 stage laminar flow protection
device. Sealed ampoules areintermittently put into the bottle feeding
tunnel by a bottle-pusher.
